Next step was to see what I could actually get my hands on, so I searched online to see what could be delivered that was at least 2x8' and pressure treated (a requirement for exterior framing). With the help of an online span calculator, I found that 2x8s should work fine for my joists. First I needed to know how deep my deck material would be. With that in mind, I started looking into materials. This created some very basic dimensions and rough location of the deck.įrom the model, it looked like about 16 feet wide and 10 feet deep would work. that should probably be your next project). To start, I threw a basic deck size/shape on the back of an existing model I had of my house (I am going to go out on a limb and say that I believe that MOST SketchUp users have some kind of a model of wherever they live. Generate plans that I could send to the building department for permitting.Get as close to exact material count as possible.Optimize material usage so I had little to no wasted material.My goal with my SketchUp model was to satisfy three requirements: With a general idea of what I wanted to build, I hopped into SketchUp to figure exactly what I needed to do to make this idea a reality. I have done quite a bit of basic framing in the past, and I have years of residential building design under my belt, so I knew I could handle the design and build myself. So I finally got around to building the deck I want on the back of my house.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |